Skip to content

Installation

The wall mounting is carried out using a standard DIN rail (EN 50022 / 35 mm x 7.5 mm). The rail is attached to the wall or in the control cabinet. Then just plug in the device on the DIN rail.

RMS-DI-L-R_installation 1
Figure 1: Wall mounting		 RMS-DI-L-R_installation 2
Figure 2: Network cable connection

When plugging the network cable into the device, make sure it clicks in audibly.

RMS-DI-L-R_installation 3

Figure 3: Battery Stick

Note:
Please remove this yellow stick to turn on the battery supply. If you don’t remove this stick, you will not be able to record data if the power supply is interrupted.