Technical specification¶
| Device type | RMS Data Logger with display | ||||||
|---|---|---|---|---|---|---|---|
| Range of application | -20..70 °C / 0..100 %rh | ||||||
| Measured Parameters | |||||||
| IP protection | IP651 | ||||||
| Storage and transport conditions | -20..30 °C / 0..100 %rh | ||||||
| Data memory | 44,000 pairs of measured values | ||||||
| Interfaces | Ethernet | ||||||
| Protocols | HTTP & MODBUS TCP | ||||||
| Software compatibility | ≥V1.1 | ≥V1.2.1 | |||||
| To confirm | If the device is in timeout, the alarm limits are stored on the device and in the case of excursions, the display will turn red (if battery only, then no backlight) and will beep (if so configured). | ||||||
| Power supply | |||||||
| Supply voltage | 24 VDC ±10 % / <100 mA2 PoE: 802.3af-2003, Class 1 Battery |
||||||
| Current consumption | <100 mA | ||||||
| Polarity protection | Yes | ||||||
| Battery life | The batteries of RMS devices typically last 3 years under the optimal conditions: - Temperature = 20°C±5°C. - Wireless signal strength >-60 dBm. - Limited “read out data” events in the audit trail. |
||||||
| Start Time and Measurement Interval | |||||||
| Start time | LAN display: <20 s | ||||||
| Measurement interval | 10 s to 15 min (the refresh rate is the same as the measurement interval). | ||||||
| Housing Specifications | |||||||
| Housing material | ABS | ||||||
| Dimensions | 105 x 113 x 38 mm | ||||||
| Weight | 200 g | ||||||
| Conformity | |||||||
| EMC directives RMS-LOG-L |
EMC Directive: 2014/30/EU LVD Directive: 2014/35/EU \ |
\ | \ | \ | --- \ | --- \ | Performance criterion: www.rotronic.com |
| Soldering material | Lead free (RoHS Directive 2011/65/EU) | ||||||
| FDA/GAMP directives | FDA CFR 21 Part 11 / GAMP5 |
1 IP65 protection is only fulfilled, when rubber plug is used for cabling.
2 Power supply requirements: 24 VDC ±10 % / >4 W / limited power source