Skip to content

Guidelines if not installing RMS on C:

The RMS application is normally installed on C:, of this is not the case, then please follow these guidelines. Should the installation be carried out on C:, this chapter can be skipped.

Step 2 Run all steps of the Installation of the RMS Software V2.8.0 Using Mixed Authentication Mode.
Step 3 In IIS, right click on Application Pool and Add Application Pool:
not on c 3
Step 4 Add RmsAppPool and click on OK:
not on c 4
Step 5 Right click on Default Web Site and select Add Application...
not on c 5
Step 6 1. Enter RMS under Alias.
2. Click on Select... to change the Application pool.
3. Within the drop down, select RmsAppPool and click on OK.
4. On the Physical path,  add the wPage folder path.
not on c 6
Step 7 Right click on Default Web Site and select Add Application...
1. Enter wService in the alias.
2. Click Select... to change the application pool.
3. Within the drop down, select RmsAppPool and click on OK.
4. On the Physical path, add the wService folder path.
not on c 7
Step 8 1. Go to the Files folder defined above.
2. Click right on the Files and select Properties.
not on c 8
Step 9 1. Switch to Security and click on Edit...
2. Then click on Add...
3. Enter IIS_IUSRS and then click on Check Names. Continue with OK.
4. Select IIS_IUSRS and give Full control. Then click on Apply and continue with OK.
not on c 9
Step 10 Continue the installation process: Software Installation Testing.

Created: 29.07.2025