Device Description¶

Functions	Description

Power Variants¶

Logging function¶

Indicator and Push-button¶

Indicator LED¶

Important:
If the RMS wireless device is offline for a longer period of time, then this may cause for the wireless module to be sent into failure mode. This happens when a very low power supply is supplied to the device. Once the wireless module is in failure mode, it cannot be resuscitated. Once the wireless module has failed, the device's LED will blink differently to any way that is described in the manual.
Recommendation: Please remove the batteries if the user anticipates keeping a wireless device disconnected for a longer period of time.

Push-button¶

The device is controlled and configured via a server application. When a device is integrated into a system, the user must confirm he is the owner of the respective device by pressing on a key.

Whether a device is integrated in the system or is primarily stored on the server. However, the device retains this information each time it communicates with the server and maintains the state in the event of a reboot or loss of connection. To remove the device from the system, it must be deleted from the server.

With a long keystroke, the local copy of the state can be discarded. Please note that the next time you communicate with the server, the state stored on the server will be adopted (if the device is integrated into the system). The function can be used as follows:

a) The device is in battery mode (no server communication) and should be temporarily deactivated (no measurement, recording).

b) The device is connected to a system which is not accessible and should now contact another server. In the integrated state, write-protection via Modbus TCP is active, which prevents settings from being overwritten. By a long keystroke this is deactivated and the new configuration can be written.

Operation external powered

Operation status	Push-button pressed
Pairing	Short time	Confirm pairing when connecting the device to the Rotronic Monitoring System. The LED flashes orange before the pairing can be confirmed. If the pairing is not confirmed, the device returns to offline mode after a certain time (determined by the RMS-WEB software).
Online	Long time (app. 4 to 5 sec.)	Discard the local pairing information. Note that pairing is always set by the server. If there is a connection to the server, the pairing is immediately taken over again.

In all operation status not listed (in the table above), the push-button has no function.

Operation battery powered

Operation status	Push-button pressed
Pairing	Short time	Display of the operation status by the LED indicator
Online	Long time (app. 4 to 5 sec.)	Stop of the logging function, turn-off the device.